SSC8 Front Bulkhead Post w/D/S clearance
Most folks who bought these thru the years needed their vehicle to convince them it will not last without using a red thread locker. Don't forget to recheck.
SSC8 A-Arm Mounts-Independent Fronts
Solid 6061 CNC-machined aluminum front a-arm mounts (9 vise/machining steps each!) with hardware.
SSC8 Low Profile Servo Mount & Front Bulkhead Kit
Includes: - G10 front bulkhead; - Aluminum front battery stop with adhesive backed rubber damper; - G10 low profile servo mount, and; - Hybrid oxide/stainless hardware kit Requires: 1-3/8" x M3 steering link, and; TLR 22-4 Aluminum servo horn
SSC8 G10 Shock Towers & Body Mounts Set
Includes: - Front G10 0.19-inch thick shock tower for F/R Traxxas GTR & F-Kyosho MP9 Tki4 shocks; - Rear G10 0.19-inch thick shock tower for R-Traxxas GTR & R-Kyosho MP9 Tki4 shocks; - Short Course body mounts' stations (4); - buggy body mounts (3); - MP9 shock spacers for vertical/free swinging alignment, and; - Hardware kit to mount both GTR and Kyosho shocks.
SSC8 Hardware Kit for Chassis
Roses are red, violets are blue this chassis is like the lady of the shop, you can't kill her and she drives you nuts, yet we thank you for convincing us to produce her again. Enjoy the good side of her ya lucky lad. The SSC8 shock towers with the Kyosho MP9 F/R shock is like watching the SSC8 chassis drive on a water bed. Silly predictable control with the recommended setup/build approach. My hub bearings are going on past 1.5yrs and even though I haven't raced in years, I'll burn thru a whole lot of packs on a practice…
SSC8 Upright Servo Mounting Hardware Kit
Includes: - 6 Aluminum spacers for servo and steering link; - Hardware
SSC8 Low Profile Lexan 1:8 eBuggy Body
Includes: - 1mm thick Lexan ssc8 buggy body for low-profile servo mount configuration; - Lexan buggy wing with spare & tuning/reinforcement plates. Requires: - Rear trimming and mounting holes; - Paint; - Mounting hole reinforcement using Shoe-Goo
SSC8 Chassis Kit for Slash 4×4
Take the fastest most efficient 4-wheel driveline in SC4x & 1:8ebuggy, couple it with the most engineered R/C chassis kit (since 2011) that weighs <1.0lbs and you get the lightest, most planted, and most durable R/C vehicle to ever run on SC4x and 1:8ebuggy tires. You can pull up to your favorite spot with the least amount of R/C gear, run the most laps or runtime on the least amount of batteries achievable at any 1:10 or 1:8 track, and leave with the least tire wear and most laps logged. 5.5lbs on 1:8ebuggy tires with 2-inches of ground clearance at…